Cart 0
Turbosmart Boost Reference Adapter (BRA) for 2015+ Ecoboost Mustang / 2016+ Focus RS (TS-0720-1004)

Turbosmart Boost Reference Adapter (BRA) for 2015+ Ecoboost Mustang / 2016+ Focus RS (TS-0720-1004)

$ 40.49

This is Turbosmart's Boost Reference Adapter (BRA) Part number: 

TS-0720-1004 for the 2015+ Ford Mustang Ecoboost and 2016+ Ford Focus RS. 

This product is used to source a vacuum/boost reference to allow your mechanical BOV to function. The Mustang has a 100% electronic BOV that is controlled by the ECU and doesn't use Vacuum/Boost at all to actuate. The Focus RS uses a vacuum/boost reference but it is connected to a solenoid that is controlled by the ECU. This causes the factory BPV to cycle during part throttle and becomes VERY annoying especially with an atmospheric BOV installed. 

For the Focus RS, this CAN be used for the factory BPV you do NOT have to have an aftermarket BOV like the Turbosmart Kompact Dual Port Shortie. 

What is included:

  • Boost Reference Adatper
  • 3 x Barb Fittings
  • 2 x 1/16NPT Plugs
  • 8" Section of Silicone Reinforced Hose (To replace factory evap line removed in instructions below)

Installation for the Ecoboost Mustang:

  • Remove engine cover
  • Locate EVAP connection behind throttle body, has a red locking clip
  • Remove RED locking clip by pushing it back
  • Disconnect the hose by pushing the clip down with your thumb 
  • Remove hose from intake manifold
  • Using heat, heat up the other end of the hose from where you disconnected and remove the plastic hose completely from the factory one-way check valve
  • Replace this hose with the supplied hose in the kit, you will connect it to the BRA using the supplied fittings. 
  • Assemble the BRA with two supplied barbed fittings. One will go to the checkvalve you removed the plastic hose from above, and the other barbed fitting will be your new source for the BOV. You can plug the remaining port.
    • Snap BRA onto the port on the intake manifold and install retaining clip
    • Zip Tie/Clamp all hose connections and you are finished

      Installation for the Focus RS:

      • Remove engine cover
      • Locate EVAP connection on left side of intake manifold just before throttle body
      • Remove WHITE locking clip by pushing it back
      • Disconnect the hose by pushing the clip down with your thumb 
      • Remove hose from intake manifold
      • Using heat, heat up the other end of the hose from where you disconnected and remove the plastic hose completely from the factory one-way check valve
      • Replace this hose with the supplied hose in the kit, you will connect it to the BRA using the supplied fittings. 
      • Assemble the BRA with two supplied barbed fittings. One will go to the checkvalve you removed the plastic hose from above, and the other barbed fitting will be your new source for the BOV. You can plug the remaining port.
      • Snap BRA onto the port on the intake manifold and install retaining clip
      • Zip Tie/Clamp all hose connections and you are finished

      Share this Product


      More from this collection